15L 300W Industrial Ultrasonic Cleaning Machine For Bicycle Chain Cleaning

15L 300W Industrial Ultrasonic Cleaning Machine For Bicycle Chain Cleaning

What Whale Cleen sonic Industrial Ultrasonic Cleaning Machine Can Do For You?

Specification:

Customer's Feedback:

Cleaning Steps Of Ultrasonic Cleaning:

1. Mix aqueous solution concentrate with hot tap water according to manufacturer's recommendations (mix in measuring cup then pour into UC, liquid should be minimum of 2/3 tank height). Time saving tip: preheat 32 oz. of water in microwave before mixing. Big time saving tip: use Swisher Tool to swish chain in boiling water to remove wax and grit before ultrasonic cleaning. This pre-cleaning will reduce the number of ultrasonic baths necessary for a clean chain.
2. Put lid on UC and plug in, set temperature to 57C (135F) and timer to 6 minutes (to degas aqueous solution). Degassing improves cleaning performance.
3. After degassing is finished, place chain in basket and basket in UC, replace lid
4. When temperature reaches 57C, set timer to clean chain for 6 minutes, then flip chain for additional 6 minutes (caution: chain, solution and tank are hot!). Note: if chain was swished in boiling water in step one to remove wax, bath temperature can be much lower than 57C.
5. Unplug UC, remove basket and place chain in large measuring cup
6. With chain in cup, fill cup with hot tap water in sink, keep water flowing into cup while agitating chain aggressively, empty and fill cup several times to flush out solution and contaminants in chain, minimum of 30 seconds intense rinsing/agitating is recommended
7. Dry chain with clean rag, note any residue marks left on rag (distinguish between dirt and simply wet marks left by chain)
8. Coffee break: it is possible to stop now if no dirt was left on rag - see additional notes at bottom of page for clarification - but for cleanest and fastest chain continue remaining steps to assure chain is as clean as possible before waxing.
9. Pour out dirty cleaning solution from tank, clean tank with paper towels, including wax clinging to sides of tank (reminder: tank is hot!)
10. Mix new solution with hot tap water as in step #1 above, pour into tank, put lid on, plug in UC
11. Set temperature to 57C and timer to 6 minutes to degas
12. After degassing is complete, place chain in basket and basket in UC, replace lid
13. When temperature reaches 57C, set timer to clean chain for 6 minutes, then flip chain for additional 6 minutes
14. Unplug UC, remove basket, place chain in cup for second rinsing as step #6 above
15. After thorough water rinse, blow chain dry with compressed air if possible, then dry with clean rag (if any marks appear on rag, repeat process with fresh concentrate and water). Note: when in doubt, replace solution and clean more!
16. Final step: place chain in clean, clear plastic container (Target "Monster Mix" container preferred) that has lid, add denatured alcohol to cover depth of chain, put lid on, swish for 45 seconds, remove chain and dry with clean rag, hang chain 15 minutes before waxing. Note: check container for debris on bottom (likely), repeat alcohol rinse with new alcohol (clean container with paper towels before refilling). For fastest chain plan on multiple alcohol baths.